Buy any ER collet chuck and get one FREE ER collet.
Upgrade to a stainless steel -UP (Ultra Precision) collet for only $19.50
Vibration Dampening w/
Superior TIR, MC is Unbeatable!
Pioneer MC Mill Chuck provides the best vibration dampening due to the unique bearing pack design.
X-Grooves provide additional driving points along the shank of the cutting tool.
The combination of the bearing pack and grooves provides the highest clamp torque of similar compression chucks in our market today.
Designed to perform without sleeves (collets), MC can be used with reducing sleeves. Please note when ever sleeves are used a loss of grip force will occur.
Unlike Hydraulic Chucks, tools with flats and special tool shanks can be used without damaging the holder. Note a loss of grip force may occur.
Reduce Tap Wear and Extend your Tap Life, 300% average tap life improvement reported!
Reduce your spindle pressure on the tap, allow the tap to cut free and increase your tool life!
Coolant Thru Tapping with Precision Sync
The holder is designed for coolant thru the center. To see the tap shank use a coolant cap matching the tap shank size to create the seal.
Required (each sold separately)
Purchase 10 Holders, Receive the 11th Free!
That's right, purchase 10 standard catalog holders and receive the 11th Free!
Mix & Match, the lowest cost holder (s) on the order will be free. Jet-Blast & FX Shell Mill are included in this promo.
Like all good things, Promo ends June 30th, 2019 . Sorry cannot be combined with any other Promotion.
Contact your local representative:
Jason VerSluys ( 330) 962-4980
Tim Stinnett ( 317) 430-7836
Blind hole tapping in aluminum with #10-24, had all the experts in using high end taps. Ran out of taps, went to a lower cost tap with this holder. No breakage! 300% improvement and a tap cost savings.